HP-UX WBEM System Fault Management (SFM) Administrator Guide (September 2013)

5 Administering indications and instances using HP SMH
This chapter describes the SysFaultMgmt (System Fault Management) (SFM) administration tasks
that you can perform using HP SMH on a local system.
This chapter addresses the following topics:
• “Viewing instances” (page 48)
• “Administering indications using Evweb” (page 53)
• “Viewing event subscriptions using Evweb” (page 60)
• “Viewing indications using Evweb” (page 64)
• “Tracing Evweb” (page 72)
• “EMT Overview” (page 76)
• “Querying the Common Error Repository” (page 75)
• “Administering Events in CER” (page 79)
• “Tracing EMT” (page 81)
Viewing instances
This section describes the tasks you must perform to view instances. This section discusses the
following topics:
• “Viewing information about processors” (page 48)
• “Viewing information about memory” (page 49)
• “Viewing information about System Summary” (page 50)
• “Viewing information about Cooling Devices” (page 50)
• “Viewing Power Supply instances” (page 50)
• “Viewing Temperature status and events” (page 50)
• “Viewing Voltage status and events” (page 50)
• “Viewing FRU information” (page 50)
• “Viewing information about Management Processor” (page 51)
• “Viewing information about Mem Error” (page 114)
• “Viewing information about Firmware information” (page 51)
• “Viewing information about Onboard Administrator” (page 51)
• “Viewing information about Complex-wide info” (page 51)
• “Viewing information about Cell Board” (page 51)
• “Viewing Partition information” (page 52)
• “Viewing information about Blade” (page 52)
• “Viewing information about Cell Blade” (page 52)
• “Viewing Health Test report of Memory” (page 52)
• “Viewing Health Test report of Processors” (page 52)
Viewing information about processors
To obtain information about processors, such as the processor type, architecture revision, and
processor speed, complete the following steps:
48 Administering indications and instances using HP SMH