HP-UX WBEM System Fault Management (SFM) Administrator Guide (September 2013)

3. For information about errors related to installation, enter the following command at the HP-UX
prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the Logfile, as underlined in the Logfile window, in the following
figure:
For example, enter the following command at the HP-UX prompt:
# swjob -a log iemlhamia-0013 @ iemlhamia.india.hp.com:/
Verifying the installation using the CLI
To verify your installation using the CLI, complete the following steps:
1. Log in to the system as a superuser.
2. Enter the following command at the HP-UX prompt:
# swjob
If the output contains no errors, the SysFaultMgmt (System Fault Management) (SFM) software
is installed properly. Otherwise, you must install the SysFaultMgmt (System Fault Management)
(SFM) software again.
A sample output is shown in the following figure:
Verifying the installation 27