HP-UX WBEM System Fault Management (SFM) Administrator Guide (September 2013)

Verifying the installation
This section describes how to verify the SysFaultMgmt (System Fault Management) (SFM) software
installation using the TUI and the CLI.
Verifying the installation using the TUI
To verify the SysFaultMgmt (System Fault Management) (SFM) software installation, complete the
following steps:
1. Log in to the system as a superuser.
2. Click Logfile in the Install window, as shown in the following figure:
The Logfile, which includes details about the installation, is displayed. If there are no errors
in the Logfile, the SysFaultMgmt (System Fault Management) (SFM) software is installed
properly. If the SysFaultMgmt (System Fault Management) (SFM) software is not installed
properly, you must repeat the installation procedure.
26 Installing the SysFaultMgmt (System Fault Management) (SFM) software