HP-UX WBEM System Fault Management (SFM) Administrator Guide (September 2013)

4. In the Specify Source window, select the appropriate location and click OK. The SD Install -
Software Selection window is displayed.
5. In the SD Install - Software Selection window, select Options-> Autoselect dependencies when
marking software.
6. Select Enforce dependency analysis errors in agent, and click OK, as shown in the following
figure. The Note window is displayed.
Selecting these options automatically installs all the dependencies.
NOTE: The system selects some options by default. However, you must select the two options
mentioned in step 5 to automatically install the prerequisites.
7. Click OK in the Note window to confirm the selection of dependencies.
8. In the SD Install - Software Selection window, select Actions->Install, as shown in the following
figure. You will need to install SysFaultMgmt, OnlineDiag and ProviderSvcsBase product
together from the DiagProdCollection bundle due to the product dependency. Verify the depot
by using swverify command.
NOTE: SysFaultMgmt (System Fault Management) (SFM) is automatically configured after it
is installed.
22 Installing the SysFaultMgmt (System Fault Management) (SFM) software