HP-UX WBEM System Fault Management (SFM) Administrator Guide (September 2013)

Table 4 Instance / Indication providers support (continued)
IA NGIS providers
2
IA legacy provider
1
PA-RISC providerInstance / Indication providers
rx2800 i2, rx2800 i4 and
rx2900 i4
√
Supported only on HP
Integrity BL860c i2, BL870c
√ХEnclosureProvider and
EnclosureStatusProvider
i2, BL890c i2, BL860c i4,
BL870c i4, & BL890c i4
√√√MPProvider and MPStatusProvider
√√√CSChassisProvider
√√√RecordLogProvider
√
Not supported on HP
Superdome 2
√√FRUProvider
Х√√EMSWrapperProvider
√√ХEvmCimProvider
√√√SFMIndicationProvider
√
Not supported on HP
Superdome 2
√XMCAIndicationProvider
√√√TemperatureSensorInstanceProvider
√√√FirmwareRevisionProvider
X√√StateChangeIndicationProvider
1
Legacy : HP Integrity platforms supporting processors prior Intel 9300.
2
NGIS : HP Integrity platfroms supporting Intel 9300 processors and Intel Itanium 9500 Processor Series
Table 5 (page 16) lists the mapping between provider module and provider.
Table 5 Mapping provider module and provider
Provider name in EventsProvider registered with CIMOMProvider Module
StateChangeIndicationProviderStateChangeIndicationProvider
SFMProviderModule
EvmCimProviderEvmCimProvider
SEL02_IndicationProvider
SFMIndicationProvider
FPL_IndicationProvider
CMC_IndicationProviderIA
CPUIndicationProvider
MemoryIndicationProviderIA
MemoryIndicationProvider
CPE_IndicationProviderIA
PCIeIndicationProvider
MCAIndicationProvider
LPMC_IndicationProviderPA
16 Introduction