HP-UX WBEM System Fault Management (SFM) Administrator Guide (September 2013)

Table 3 Indication providers (continued)
DescriptionIndication provider
• CMC Monitor (cmc_em)
• Itanium Core Hardware Monitor(ia64_corehw)
• Itanium Memory Monitor (memory_ia64)
NOTE: This provider and WBEM to EMS Consumer is not
supported on HP Integrity BL860c i2, BL870c i2 & BL890c i2
Server Blades, HP Integrity rx2800 i2 server, HP Integrity
Superdome 2, HP Integrity BL860c i4, BL870c i4, BL890c i4,
rx2800 i4 and rx2900 i4.
For a list of EMS Event Descriptions, see:
http://www.hp.com/go/
hpux-diagnostics-online-events
The EVM CIM provider does the following:EvmCimProvider
1. Converts hardware, software, and kernel events generated by
the EVM into WBEM indications.
2. Reports the WBEM indications to the CIMOM. Using a
WBEM-based management application, such as HP SIM, you
can subscribe to and receive EVM events generated on a
remote system. On the system on which SysFaultMgmt (System
Fault Management) (SFM) is installed, you can use an
SysFaultMgmt (System Fault Management) (SFM) tool, called
EVWEB, to view and administer events through the HP SMH
interface.
3. Logs messages logged by EVMCimProvider in
/var/opt/sfm/EvmCimProvider.log log file.
The SFMIndicationProvider generates indications that are compliant
with the WBEM standards. On HP Integrity systems, it replaces
the following EMS monitors:
SFMIndicationProvider
• cmc_em
• cpe_em
• memory_ia64
• fpl_em
• ia64_corehw
On HP 9000 systems, it replaces the following EMS monitors:
• fpl_em
• ia64_corehw
On HP Superdome 2, the core analysis engine monitors core
hardware and generates events. DPR and PCI Error Recovery
events are generated on HP-UX . The following indication providers
generate the event respectively:
• CMC_IndicationProviderIA
• PCIeIndicationProvider
You can choose to use either the SFMIndicationProvider or the
EMS monitors that it replaces, to monitor your hardware. The
remaining EMS monitors continue to function as usual irrespective
of whether you choose the SFMIndicationProvider or the EMS
monitors that it replaces. If you choose the SFMIndicationProvider,
it does the following:
1. Generates WBEM indications equivalent to the events that the
monitors it replaces generate.
2. Reports these WBEM indications to the CIMOM.
In the WBEM indication details, the provider name displayed
corresponds with the device to which the indication is related. For
14 Introduction