HP-UX WBEM System Fault Management (SFM) Administrator Guide (September 2013)

Table 57 FMLoggerConfig.xml file configuration parameters (continued)
Range valueDefault valueParameter
2KB to 1048576 KB (1 GB)20480FileSize
1 to 103NBackupFiles
evweb.conf
The evweb.conf is a configuration file used to set parameters used by the email consumer.
SysFaultMgmt (System Fault Management) (SFM) allows the evweb.conf being modified at
anytime and take effect immediately by executing the following command:
NOTE: If the email server is not set to local machine, it is required to add hostname of generating
events server into /etc/mail/sendmail.cw file on the email server and restart sendmail of the
email server. Else, the events mail will not be delivered to subscribed-ID defined in subscription.
# sfmconfig -c /var/opt/sfm/conf/evweb.conf
Table 58 (page 130) describes the parameters to configure
Table 58 evweb.conf file configuration parameters
DescriptionRange valueDefault valueParameter
This tag contains the IP address of the server used
as the email server. By default, it is set as 127.0.0.1
NA127.0.0.1EMAILSERVER / IP
which is the IP address of the local machine. If this
value is set, then the value inside the 'FULLNAME'
tag is ignored.
This is the Fully Qualified Domain Name of the
machine used as the email server. This is considered
NAlocalhostEMAILSERVER /
FULLNAME
only if the email server's IP address is not defined
in the 'IP' tag
This tag defines the 'from' email address using
which the email is sent. The administrator has to
provide an appropriate address here.
[e-mail]
130 SysFaultMgmt (System Fault Management) (SFM) configuration files