HP-UX WBEM System Fault Management (SFM) Administrator Guide (September 2013)

D SysFaultMgmt (System Fault Management) (SFM)
configuration files
This appendix describes the items of different configuration files in SysFaultMgmt (System Fault
Management) (SFM). The user can configure only the following three files:
• “DBConfig.xml” (page 129)
• “FMLoggerConfig.xml” (page 129)
• “evweb.conf” (page 130)
DBConfig.xml
The DBConfig.xml is a configuration file used to set SysFaultMgmt (System Fault Management)
(SFM) DB parameters of the Event storage (evweb) and the Common Log storage (LOGDB)
databases, and their corresponding archive database (evweb_history and LOGARCHDB).
SysFaultMgmt (System Fault Management) (SFM) allows the DBConfig.xml being modified at
anytime and take effect immediately by executing the following command:
# sfmconfig -c /var/opt/sfm/conf/DBConfig.xml
Table 56 (page 129) describes the parameters to configure Event and Common Log database.
Table 56 DBConfig.xml file configuration parameters
Range valueDefault valueParameter
10 to 400140DBConfig /MaxNumPagesAllowed
1 to 1010DBConfig / DBRecordLifeTime
30 to 365365DBConfig / ArchedRecordLifetime
10 to 400340DBConfig / ArchDBSize
10 to 400100EvwebDBConfig
/MaxNumPagesAllowed
1 to 1010EvwebDBConfig / DBRecordLifeTime
30 to 365365EvwebDBConfig /
ArchedRecordLifetime
FMLoggerConfig.xml
The FMLoggerConfig.xml is a common configuration file used to set parameters for log messages
files generated by SysFaultMgmt (System Fault Management) (SFM) and evweb.
SysFaultMgmt (System Fault Management) (SFM) allows the FMLoggerConfig.xml being modified
at anytime and take effect immediately by executing the following command:
# sfmconfig –c /var/opt/sfm/conf/FMLoggerConfig.xml
Table 57 (page 129) describes the parameters to configure
Table 57 FMLoggerConfig.xml file configuration parameters
Range valueDefault valueParameter
MILESTONE, INFORMATIONAL,
WARNING, ERROR, CRITICAL,
STOPLOGGING
WARNINGSeverity
NA/var/opt/sfm/log/sfm.logTarget
DBConfig.xml 129