HP-UX SysFaultMgmt (System Fault Management) (SFM) Administrator Guide (762798-001, March 2014)

6 Administering indications and instances using HP SMH

This chapter describes SysFaultMgmt (System Fault Management) (SFM) administration tasks

that you can perform using HP SMH on a local system.

This chapter addresses the following topics:

• “Viewing instances” (page 53)

• “Administering indications using Evweb” (page 58)

• “Viewing event subscriptions using Evweb” (page 65)

• “Viewing indications using Evweb” (page 69)

• “Tracing Evweb” (page 77)

• “EMT Overview” (page 81)

• “Querying the Common Error Repository” (page 81)

• “Administering Events in CER” (page 84)

• “Tracing EMT” (page 87)

Viewing instances

This section describes the tasks you must perform to view instances. This section discusses the

following topics:

• “Viewing information about processors” (page 53)

• “Viewing information about memory” (page 54)

• “Viewing information about System Summary” (page 55)

• “Viewing information about Cooling Devices” (page 55)

• “Viewing Power Supply instances” (page 55)

• “Viewing Temperature status and events” (page 55)

• “Viewing Voltage status and events” (page 55)

• “Viewing FRU information” (page 55)

• “Viewing information about Management Processor” (page 56)

• “Viewing information about Mem Error” (page 56)

• “Viewing information about Firmware information” (page 56)

• “Viewing information about Onboard Administrator” (page 56)

• “Viewing information about Complex-wide info” (page 56)

• “Viewing information about Cell Board” (page 56)

• “Viewing Partition information” (page 57)

• “Viewing information about Blade” (page 57)

• “Viewing information about Cell Blade” (page 57)

• “Viewing Health Test report of Memory” (page 57)

• “Viewing Health Test report of processors” (page 57)

Viewing information about processors

To obtain information about processors, such as the processor type, architecture revision, and

processor speed, complete the following steps:

Viewing instances 53