HP-UX SysFaultMgmt (System Fault Management) (SFM) Administrator Guide (762798-001, March 2014)

Table 14 Status values
Status values
UNKNOWN
OTHER
OK
DEGRADED
STRESSED
PREDICTIVE FAILURE
ERROR
NONRECOVERABLE ERROR
STARTING
STOPPING
STOPPED
IN SERVICE
NO CONTACT
LOST COMMUNICATION
ABORTED
DORMANT
SUPPORTING ENTITY IN ERROR
COMPLETED
The sfmconfig -a -r command is used to change the state of a subsystem. When this command
is not working with processor, the user should check for errors. When a CPU is deactivated on a
system due to an action taken against an error symptom, the user tries to use sfmconfig command
to make the CPU state back to OK The change does not happen unless the processor which is
faulty is replaced or it is acquitted from the Onboard Administrator on HP Superdome 2.
Viewing instances
To view information about processors, memory, cooling devices, power supplies, and disks,
complete the following steps:
48 Administering indications and instances using HP SIM