HP-UX SysFaultMgmt (System Fault Management) (SFM) Administrator Guide (762798-001, March 2014)

Verifying removal of SysFaultMgmt (System Fault Management) (SFM)
software
This section describes how to use the TUI and the CLI to verify whether SysFaultMgmt (System
Fault Management) (SFM) software is removed successfully.
Verifying removal using the TUI
To verify whether SysFaultMgmt (System Fault Management) (SFM) software is removed
successfully, complete the following steps:
1. Log in to the system as a superuser.
2. Click Logfile in the Remove Window.
If there are no errors in the Logfile, SysFaultMgmt (System Fault Management) (SFM)
software is removed successfully. If SysFaultMgmt (System Fault Management) (SFM) software
is not removed properly, you must repeat the removal procedure. See “Removing SysFaultMgmt
(System Fault Management) (SFM) software” (page 29) for instructions on how to remove
SysFaultMgmt (System Fault Management) (SFM) software.
3. For information about errors related to the removal of SysFaultMgmt (System Fault
Management) (SFM), enter the following command at the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the Logfile.
Verifying removal using the CLI
To verify if SysFaultMgmt (System Fault Management) (SFM) software is removed successfully,
complete the following steps:
1. Log in to the system as a superuser.
2. Enter the following command at the HP-UX prompt:
# swjob
If the output contains no errors, SysFaultMgmt (System Fault Management) (SFM) software
is removed successfully. If SysFaultMgmt (System Fault Management) (SFM) software is not
removed properly, you must repeat the removal procedure. See “Removing SysFaultMgmt
(System Fault Management) (SFM) software” (page 29) for instructions on how to remove
SysFaultMgmt (System Fault Management) (SFM) software.
3. For information about errors related to the removal of SysFaultMgmt (System Fault
Management) (SFM) software, enter the following command at the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the output of the swjob command.
Verifying removal of SysFaultMgmt (System Fault Management) (SFM) software 33