HP-UX SysFaultMgmt (System Fault Management) (SFM) Administrator Guide (762798-001, March 2014)

9. Unmount the CD. To unmount, enter the following command at the HP-UX prompt:
# unmount /tmp/cdrom
10. To verify whether SysFaultMgmt (System Fault Management) (SFM) software is installed
properly, enter the following command at the HP-UX prompt:
# swlist | grep SysFaultMgmt
If SysFaultMgmt (System Fault Management) (SFM) software is installed properly, SysFaultMgmt
and the version number of SysFaultMgmt (System Fault Management) (SFM) software are
displayed in the output. If SysFaultMgmt (System Fault Management) (SFM) software is not
installed properly, you must repeat the installation procedure. For more information, see
“Verifying the installation” (page 27).
Installing using the CLI
To install SysFaultMgmt (System Fault Management) (SFM) software using CLI, complete the
following steps:
1. Log in to the system as a superuser.
2. Mount the CD to a location of your choice, as in the following example:
# mount /dev/dsk/c1t2d0 /tmp/cdrom
3. To install SysFaultMgmt (System Fault Management) (SFM) software and all the dependencies,
enter the following command at the HP-UX prompt:
# swinstall -x autoselect_dependencies=true -x
enforce_dependencies=true -s /tmp/cdrom SysFaultMgmt
4. Unmount the CD. To unmount, enter the following command at the HP-UX prompt:
# unmount /tmp/cdrom
5. To verify whether SysFaultMgmt (System Fault Management) (SFM) software is installed
properly, enter the following command at the HP-UX prompt:
# swlist | grep SysFaultMgmt
If SysFaultMgmt (System Fault Management) (SFM) software is installed properly,
SysFaultMgmt and the version number of SysFaultMgmt (System Fault Management)
(SFM) software appear in the output. If SysFaultMgmt (System Fault Management) (SFM)
software is not installed properly, you must repeat the installation procedure. For more
information, see “Verifying the installation” (page 27).
Installing SysFaultMgmt (System Fault Management) (SFM) software from the media 25