HP-UX SysFaultMgmt (System Fault Management) (SFM) Administrator Guide (762798-001, March 2014)

• SysMgmtPlus Version A.04.00, September 2010 release or later
• OnlineDiag Version B.11.31.06.xx on HP 9000 systems only, September 2009 release or
later (OnlineDiag B.11.31.22.02, September 2013 release is the latest version)
A.04.20.31EMS Version
D.06.00STM Version
NOTE:
• The listed versions of the software are the minimum supported requirements. Subsequent
versions are compatible with this version of SysFaultMgmt (System Fault Management)
(SFM) unless otherwise noted.
• WBEM Services, Online Diagnostics, SysMgmtWeb, and HP SIM are available on the
Operating Environment (OE) media and can be selected for install during SysFaultMgmt
(System Fault Management) (SFM) installation.
• HP System Management Homepage (SMH) – bundled in SysMgmtWeb. You cannot access
the EvWEB GUI (Event Viewer, Subscription Administration and Log Viewer interface), EMT(Error
Management Technology) GUI and IPMI Event Viewer GUI without HP SMH. The command
line interface for EVWEB, EMT and IPMI Event Viewer (Slview) will still be accessible.
• HP Systems Insight Manager (HP SIM) is an optional install. However, HP recommends using
the latest available version to remotely administer indications and instances available on HP
SIM page.
• Starting from HP-UX 11i v3 September 2011 release, all the products namely
ProviderSvcsBase (PSB), SysFaultMgmt (System Fault Management) (SFM), the I/O
Providers namely HP-UX WBEM RAIDSA Provider, HP-UX WBEM SAS Provider, HP-UX WBEM
FC (Fibre-Channel) Provider, HP-UX WBEM DAS (Direct Attached Storage) Provider must be
installed together to maintain compatibility among the diagnostic products.
Installing SysFaultMgmt (System Fault Management) (SFM) software from
the media
This section describes the two ways in which you can install SysFaultMgmt (System Fault
Management) (SFM) software from the HP-UX 11i v3 OE media:
• Using the terminal user interface (TUI)
• Using the command-line interface (CLI)
Installing using the TUI
To install SysFaultMgmt (System Fault Management) (SFM) software using the TUI, complete the
following steps:
1. Log in to the system as a superuser.
2. Mount the CD to a location of your choice as in the following example:
# mount /dev/dsk/c1t2d0 /tmp/cdrom
3. Enter the following command at the HP-UX prompt:
# swinstall
The SD Install - Software Selection window appears as shown in the following figure:
22 Installing SysFaultMgmt (System Fault Management) (SFM) software