Administrator's and User's Guide for SFM HP-UX 11i v3 September 2010

5 Administering Indications and Instances Using HP SMH
This chapter describes the SFM administration tasks that you can perform using HP SMH on a
local system.
This chapter addresses the following topics:
• “Viewing Instances”
• “Administering Indications Using Evweb”
• “Viewing Event Subscriptions Using Evweb”
• “Viewing Indications Using Evweb”
• “Tracing Evweb”
• “EMT Overview”
• “Querying the Common Error Repository”
• “Administering Events in CER”
• “Tracing EMT”
Viewing Instances
This section describes the tasks you must perform to view instances. This section discusses the
following topics:
• “Viewing Information About Processors”
• “Viewing Information About Memory”
• “Viewing Information About System Summary”
• “Viewing Information About Cooling Devices”
• “Viewing Power Supply Instances”
• “Viewing Temperature Status and Events”
• “Viewing Voltage Status and Events”
• “Viewing FRU Information”
• “Viewing Information About Management Processor”
• “Viewing Information About Firmware Information”
• “Viewing Information About Onboard Administrator”
• “Viewing Information About Complex-wide Info”
• “Viewing information About Cell Board”
• “Viewing Partition Information”
• “Viewing Information About Blade”
• “Viewing Information About Cell Blade”
• “Viewing Health Test report of Memory”
• “Viewing Health Test report of Processors”
Viewing Information About Processors
To obtain information about processors, such as the processor type, architecture revision, and
processor speed, complete the following steps:
Viewing Instances 47