Administrator's and User's Guide for SFM HP-UX 11i v3 March 2013

0000010 509 0 0 0 500 200 300d 0
0000020 2538 300 1112 920 0 0 0 0
0000030 0 0 0 0 f7fa 29e4 b73c d411
0000040 bca7 80 c73c 8881 500 0 80d 0
0000050 4000 0 0 0 0 0 0 0
0000060 0 0 0 0 0 0 0 0
For information on viewing details of low level logs using the CLI, see evweb_logviewer(1).
Tracing Evweb
This section provides an overview of tracing and information about the various trace levels in
Evweb. This section also describes administrative tasks, such as enabling, modifying, and disabling
tracing.
This section addresses the following topics:
• “Enabling Tracing using the Evweb GUI” (page 71)
• “Enabling Tracing using the Evweb CLI” (page 72)
• “Modifying Tracing using the Evweb GUI” (page 72)
• “Modifying Tracing using the Evweb CLI” (page 72)
• “Disabling Tracing using the Evweb GUI” (page 73)
• “Disabling Tracing using the Evweb CLI” (page 73)
Tracing is a feature that enables you to log and report errors. You can use tracing to log information
about problems encountered while using Evweb. In this document, this information is referred to
as trace records. The trace records are stored in the /var/opt/sfm/log/sfm.log file. The
logs are written when SFM is running. These logs are Warning, informational, Milestone etc based
on the kind of severity set by the user. You can send the sfm.log file to the HP support center
whenever you encounter a problem.
Following is a sample of the information logged in sfm.log.
01/04/06 06:50:08 EVMAN_COMMANDS ERROR 1069627450 1 Subscription with
this name already exist, Please choose different name and try again.
Table 16 describes the fields included in the sfm.log file.
Table 16 Entries in sfm.log
DescriptionField
Displays the date when the message was logged in the sfm.log file.Date
Displays the time when the message was logged in the sfm.log file.Time
Displays the name of the module or the providers that logged the message
in the sfm.log file, for example, EVWEB_CLI and FMDProviders.
Module Name
Displays the severity of the message logged in the sfm.log file.Severity
Displays the 10-digit process ID.Process ID
Displays the thread ID.Thread ID
Displays the text message.Message
To change the default location of the sfm.log file, you must configure the
/var/opt/sfm/conf/FMLoggerConfig.xml file.
You can enable, modify, and disable tracing for an Evweb session. A session is the duration
between a login and a logout. At the end of a session, tracing is automatically disabled. In an
active session, the trace level remains valid until you modify it.
70 Administering indications and instances using HP SMH