Administrator's and User's Guide for SFM HP-UX 11i v3 March 2013

5 Administering indications and instances using HP SMH

This chapter describes the SFM administration tasks that you can perform using HP SMH on a local

system.

This chapter addresses the following topics:

• “Viewing instances” (page 46)

• “Administering indications using Evweb” (page 51)

• “Viewing event subscriptions using Evweb” (page 58)

• “Viewing indications using Evweb” (page 62)

• “Tracing Evweb” (page 70)

• “EMT Overview” (page 73)

• “Querying the Common Error Repository” (page 73)

• “Administering Events in CER” (page 76)

• “Tracing EMT” (page 79)

Viewing instances

This section describes the tasks you must perform to view instances. This section discusses the

following topics:

• “Viewing information about processors” (page 46)

• “Viewing information about memory” (page 47)

• “Viewing information about System Summary” (page 48)

• “Viewing information about Cooling Devices” (page 48)

• “Viewing Power Supply instances” (page 48)

• “Viewing Temperature status and events” (page 48)

• “Viewing Voltage status and events” (page 48)

• “Viewing FRU information” (page 48)

• “Viewing information about Management Processor” (page 49)

• “Viewing information about Mem Error” (page 112)

• “Viewing information about Firmware information” (page 49)

• “Viewing information about Onboard Administrator” (page 49)

• “Viewing information about Complex-wide info” (page 49)

• “Viewing information about Cell Board” (page 49)

• “Viewing Partition information” (page 50)

• “Viewing information about Blade” (page 50)

• “Viewing information about Cell Blade” (page 50)

• “Viewing Health Test report of Memory” (page 50)

• “Viewing Health Test report of Processors” (page 50)

Viewing information about processors

To obtain information about processors, such as the processor type, architecture revision, and

processor speed, complete the following steps:

46 Administering indications and instances using HP SMH