Administrator's and User's Guide for SFM HP-UX 11i v3 March 2013

NOTE: The Severity levels in Table 10 indicate EMS severity.
Table 11 Default event destinations for SysFaultMgmt
SysFaultMgmtSeverity levels
Default notification
method
textlog: /var/opt/sfm/log/event.logAllTextlog
AvailableMAJORSyslog
CRITICAL
FATAL/NON-RECOVERABLE
Not AvailableNoneE-MAIL
AvailableAllEvweb DB
(evweb eventviewer -L)
NOTE: The Severity levels in Table 11 indicate WBEM severity.
For a list of WBEM indications generated by all the monitors, see the EMS event descriptions at:
http://www.hp.com/go/hpux-diagnostics-online-events
Table 12 (page 44) lists all the values as Status in sfmconfig -a -L.
Table 12
Status values
UNKNOWN
OTHER
OK
DEGRADED
STRESSED
PREDICTIVE FAILURE
ERROR
NONRECOVERABLE ERROR
STARTING
STOPPING
STOPPED
IN SERVICE
NO CONTACT
LOST COMMUNICATION
ABORTED
DORMANT
SUPPORTING ENTITY IN ERROR
COMPLETED
The sfmconfig -a -r command is used to change the state of a subsystem. When this command
is not working with processor, the user should check for errors. When a CPU is deactivated on a
system due to an action taken against an error symptom, the user tries to use sfmconfig command
44 Administering indications and instances using HP SIM