Administrator's and User's Guide for SFM HP-UX 11i v3 March 2013

9. To verify if products in WBEMMgmtBundle are installed successfully, run the following command
at the HP-UX prompt:
# swverify <product name>
For ex: Use the following command to verify SysFaultMgmt product
# swverify SFM-CORE
If the product is installed successfully on your system, the following message is displayed:
Verification succeeded
If the products are not installed successfully on your system, run the following command at the
HP-UX prompt to view the log file for errors:
# grep -i error /var/adm/sw/swagent.log
Fix the error and reinstall the product.
Verifying the installation
This section describes how to verify the SFM software installation using the TUI and the CLI.
Verifying the installation using the TUI
To verify the SFM software installation, complete the following steps:
1. Log in to the system as a superuser.
2. Click Logfile in the Install window, as shown in the following figure:
The Logfile, which includes details about the installation, is displayed. If there are no errors
in the Logfile, the SFM software is installed properly. If the SFM software is not installed
properly, you must repeat the installation procedure.
24 Installing the SFM software