Administrator's and User's Guide for SFM HP-UX 11i v3 March 2013

3. To install the SFM software and all the dependencies, enter the following command at the
HP-UX prompt:
# swinstall -x autoselect_dependencies=true -x
enforce_dependencies=true -s /tmp/cdrom SysFaultMgmt
4. Unmount the CD. To unmount, enter the following command at the HP-UX prompt:
# unmount /tmp/cdrom
5. To verify whether the SFM software is installed properly, enter the following command at the
HP-UX prompt:
# swlist | grep SysFaultMgmt
If the SFM software is installed properly, SysFaultMgmt and the version number of the SFM
software appear in the output. If the SFM software is not installed properly, you must repeat
the installation procedure. For more information, see “Verifying the installation” (page 24).
Installing the SFM software from the web
The SFM depot is available for download on the OE media and web. Starting from HP-UX 11i v3
September 2011 release, all the products namely ProviderSvcsBase, SysFaultMgmt, the I/O
Providers namely HP-UX WBEM RAIDSA Provider, HP-UX WBEM SAS Provider, HP-UX WBEM
Fibre-Channel Provider, HP-UX WBEM Direct Attached Storage Provider (DASProvider) must be
installed together to maintain compatibility among the diagnostic products.
On web:
September 2011 web release onwards, all the HP-UX 11i v3 version of WBEM
providers and Diagnostics products, are available for download on the WBEM
Management bundle for HP-UX 11i v3 bundle page at https://
h20392.www2.hp.com/portal/swdepot/displayProductInfo.do?
productNumber=WBEMMgmtBundle.
NOTE: HP's WBEM Management bundle is released only on the web. All the
products from the WBEM Management bundle must be installed together. This is
due to product interdependency. These products might not work if they are installed
individually.
Installing and Upgrading Products from the Bundle
1. Go to HP Software Depot at http://software.hp.com/.
2. Search for WBEMMgmtBundle and select WBEM Management bundle for HP-UX 11i v3. The
Overview page is displayed. This page provides the details of solution for installation/upgrade
of WBEM Management products bundle.
3. Go to the Installation page and review Prerequisites to ensure that your system meets the
requirements.
4. Select the Receive for Free >> option at the bottom right of the page.
5. Select the appropriate release of the HP-UX operating system.
6. Enter your registration information. Read and accept the terms and conditions.
7. Click Next >> at the bottom right of the page.
8. Click the appropriate link under Download Software to download the software. on to your
local system and install the bundle using the following command:
# swinstall -s / WBEMMgmtBundle
Installing the SFM software from the web 23