Administrator's and User's Guide for SFM HP-UX 11i v3 April 2010

1. Repeat steps 1-5 from “Launching EMT” (page 75).
NOTE: The Disable Tracing option is not displayed if tracing is not enabled.
2. Select Disable Tracing on the top right corner of the Simple Search page.
The tracing is disabled and a confirmation message is displayed.
3. Click OK on the confirmation message window.
For more information about disabling tracing using the HP SMH GUI, select Help on the action
pane of the Disable Tracing page.
Disabling Tracing Using the EMT CLI
To disable tracing using the EMT CLI, you must reset the trace value. To reset the trace value,
enter the following command at the HP-UX prompt:
# unset EMT_TRACE_LEVEL
Tracing is now disabled.
NOTE: Tracing is automatically disabled at the end of an EMT session.
82 Administering Indications and Instances Using HP SMH