Administrator's and User's Guide for SFM HP-UX 11i v3 April 2010

NOTE: WBEM Services, Online Diagnostics, SysMgmtWeb, and HP SIM are available on the
Operating Environment (OE) media and can be selected for install during the SFM installation.
HP System Management Homepage (SMH) – bundled in SysMgmtWeb – is an optional install.
However, without it you cannot access the EvWEB GUI (Event Viewer, Subscription Management
and Log Viewer interface). The command line interface for EVWEB will still be accessible.
HP Systems Insight Manager (HP SIM) is an optional install. However, HP recommends using
the latest available version to remotely administer indications and instances. The minimum
requirements are the April/May 2007 release: HP SIM 5.1 with Update 1 - HP-UX (C.05.01.00.01).
Installing the SFM Software from the Media
This section describes the two ways in which you can install the SFM software from the HP-UX
11i v3 OE media:
• Using the terminal user interface (TUI)
• Using the command-line interface (CLI)
Installing Using the TUI
To install the SFM software using the TUI, complete the following steps:
1. Log in to the system as a superuser.
2. Mount the CD to a location of your choice as in the following example:
# mount /dev/dsk/c1t2d0 /tmp/cdrom
3. Enter the following command at the HP-UX prompt:
# swinstall
The SD Install - Software Selection window appears as shown in the following figure:
4. In the Specify Source window, select the appropriate location and click OK. The SD Install
- Software Selection window is displayed.
5. In the SD Install - Software Selection window, select Options-> Autoselect dependencies
when marking software.
6. Select Enforce dependency analysis errors in agent, and click OK, as shown in the following
figure. The Note window is displayed.
20 Installing the SFM Software