Administrator's and User's Guide for SFM HP-UX 11i v2 December 2008

3. For information about errors related to the removal of SFM, enter the following command
at the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the Logfile.
Verifying Removal Using the CLI
To verify if the SFM software is removed successfully, complete the following steps:
1. Log in to the system as a superuser.
2. Enter the following command at the HP-UX prompt:
# swjob
If the output contains no errors, the SFM software is removed successfully. If the SFM
software is not removed properly, you must repeat the removal procedure. See “Removing
the SFM Software” (page 25) for instructions on how to remove the SFM software.
3. For information about errors related to the removal of the SFM software, enter the following
command at the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the output of the swjob command.
Verifying Removal of the SFM Software 29