Administrator's and User's Guide for SFM HP-UX 11i v2 December 2008

2 Installing the SFM Software
The System Fault Management (SFM) software is installed by default with the HP-UX 11i v2
Operating Environment (OE) media. However, at some point you may need to install the SFM
software separately. This chapter describes how to install the SFM software as a standalone
component on the HP-UX 11i v2 operating system.
This chapter discusses the following topics:
• “Prerequisites” (page 19)
• “Installing the SFM Software from the Media” (page 19)
• “Installing the SFM Software from the Web” (page 22)
• “Verifying the Installation” (page 23)
• “Removing the SFM Software” (page 25)
• “Verifying Removal of the SFM Software” (page 28)
Prerequisites
Following are the prerequisites for installing the March 2008 version of SFM software:
• June 2007 HP-UX 11i v2 Operating Environment Update Release (OEUR) or later
• OpenSSL Version A.00.09.07e.013 or later
• WBEMServices A.02.02.05 WBEM Services CORE Product
• SysMgmtWeb Version A.2.2.5 (HP-UX Web-Based System Management User Interface)
• Online Diagnostics (OnlineDiag bundle version B.11.23.09.xx)
• PHKL_34795 IPMI patch
NOTE: SysMgmtWeb is optional. However, you can not access Evweb GUI if SysMgmtWeb is
not installed on the system. SysMgmtWeb, WBEMServices A.02.02.05, and Online Diagnostics
are available on the Operating Environment (OE) media.
The OnlineDiag bundle is always installed with the OE media.
HP recommends that you install HP Systems Insight Manager (HP SIM) version C. 05.01.00.01.xx
or later to remotely administer indications and instances.
The mentioned versions of the software are minimum requirements. All future versions support
SFM by default.
Installing the SFM Software from the Media
This section describes the two ways in which you can install the SFM software from the HP-UX
11i v2 OE media:
• Using the terminal user interface (TUI)
• Using the command-line interface (CLI)
Installing Using the TUI
To install the SFM software using the TUI, complete the following steps:
1. Log in to the system as a superuser.
2. Mount the CD to a location of your choice as in the following example:
# mount /dev/dsk/c1t2d0 /tmp/cdrom
3. Enter the following command at the HP-UX prompt:
# swinstall
The SD Install - Software Selection window appears as shown in the following figure:
Prerequisites 19