HP-UX System Administrator's Guide: Routine Management Tasks HP-UX 11i v3 (B3921-90023, September 2010)

boottest testname on Enable the specified test (testname). For
example: boottest io_hw on enables the
boot-time I/O hardware self tests.
boottest testname off Disable the specified test (testname). For
example: boottest Chipset off disables
the Chipset boot-time system test.
3. Repeat Step 2 until the settings reflect your desired settings, then reboot your
system.
Configuring Boot-Time System Tests from a Booted System
SpeedyBoot tests are configured with three setboot options:
-v
Displays a status table of the SpeedyBoot test settings.
-t testname=value Change the value for the test testname in nonvolatile
memory to value for all following boots. The changes are
reflected in the Current and Next Boot columns of the
SpeedyBoot table.
testname
One of the following keywords, as described
in Table 2-2 (page 71):
• all
• SELFTESTS
• early_cpu
• late_cpu
• FASTBOOT
• full_memory
• PDH
• CEC
value
One of:
• on
Enable the test.
• off
Disable the test.
• default
Reset the test to the system default,
which is shown in the Defaults column
of the SpeedyBoot table.
76 Booting and Shutdown