HP-UX System Administrator's Guide: Configuration Management

pci_error_tolerance_time, the card in the I/O slot will be suspended and
you will need to attempt a manual recovery operation to restore the card.
PCI Error Recovery Documentation
PCI Error Recovery is supported by the following documentation, available on the HP
Technical Documentation web site at http://docs.hp.com:
In the High Availability section:
• PCI Error Recovery Product Note
• PCI Error Recovery Support Matrix
• Interface Card OL* Support Guide
In the HP-UX Reference:
• pci_eh_enable(5) manpage
• pci_error_tolerance_time(5) manpage
Ethernet Configuration and Verification
See also the HP-UX LAN Administrator's Guide.
Use this procedure to configure and verify any type of HP-UX 11i v3-based Ethernet
type cards including 10 Gigabit Ethernet, Gigabit Ethernet, and Fast Ethernet.
Procedure 9-1 Installation, Configuration, and Verification Procedure
1. Install LAN card (if needed) and attach cables to it according to instructions in the
server’s hardware support document.
2. Plug LAN card into the appropriate switch port.
3. Boot the system.
4. To see all LAN cards with drivers, run:
# ioscan -fnC lan
5. If you do not see your card, use ioscan to determine if the card is there but needs
a driver (UNCLAIMED).
# ioscan -fn
If your LAN card is a built-in card or was factory installed, the software bundle
required for the card is already loaded onto your system’s hard drive.
6. Install or update the driver if needed (to the latest version). Get the latest driver
from the latest quarterly update media for your version of HP-UX. To add new
software, see “Installing or Updating a Networking Driver with swinstall”
(page 136).
7. Verify connectivity to the switch.
# nwmgr -c lanPPA -A link_state,speed
8. View cards with IP addresses.
Ethernet Configuration and Verification 135