HP-UX System Administrator's Guide: Configuration Management HP-UX 11i v3 (B3921-90017, September 2010)

Establishing an FTP Connection from HP-UX to a PC
NOTE: See also “Establishing an FTP Connection from a PC to HP-UX” (page 101).
Before starting the following procedure, make sure FTP is set up for the kind of access
you need. The default is to allow only anonymous access. If you want to allow individual
user access, you can do this with the Internet Services Manager on your PC.
1. On your HP-UX system, start the FTP utility by entering the command:
# /usr/bin/ftp
2. Open a connection to your PC using ftp’s open command:
ftp> open vectrapc1.net2.corporate
If the connection is successful, FTP will let you know that you are connected and
display information about the PC’s FTP server:
Connected to vectrapc1.net2.corporate.
220 vectrapc1 Microsoft FTP Service (Version 2.0).
If your connection succeeded, proceed to Step 3. If it fails, use Table 5-3 (page 95).
94 Configuring Networking