Software Distributor (SD-UX) Administration Guide HP-UX 11i v1, 11i v2, and 11i v3 (762797-001, March 2014)

The Target Selection Window displays a list of targets may be displayed:
• If you have recalled a session file (File→Recall Session), any hosts defined in that session are
displayed.
• Otherwise, any hosts specified in the default hosts file (/var/adm/sw/defaults.hosts
or $HOME/.sw/defaults.hosts) are displayed. (See “Preselecting Host Files” (page 26).)
If the desired target for the installation is not in the list:
1. Choose Actions→Add Targets.... The Add Targets dialog (Figure 46: “Add Targets Dialog ”,)
is displayed.
Figure 46 Add Targets Dialog
2. Enter the primary root name in the Hostname: area and select Add.
3. The Select Target Path dialog appears. The default path is root (/). To accept the default root
(/), click OK.
4. After selecting the root path, the Hostname and Root Path are automatically updated in the
Add Target dialog (Figure 46: “Add Targets Dialog ”,). To add additional targets, repeat 2.
5. Select OK in the Add Targets dialog. This adds your selections to the Target Selection Window.
Each target is contacted as it is added to the Target Selection Window. Networking may
cause delays; if the SD-UX daemon is not running on the target, the delay lasts until the daemon
times out.
From the Target Selection Window, any targets added using Add Targets... are automatically
marked Yes.
6. If there are any other desired targets in the Target Selection List that are not marked and you
want to install to them, highlight the target by clicking on it.
Choose Actions→Mark for Install. The Marked? column is set to Yes for that target.
Using the Remote Operations GUI 119