Software Distributor Requirements, Issues Fixed, and Workarounds HP-UX 11i v2, HP-UX 11i v3

• swlist Does Not Indicate the Mezzanine HBAs
swlist does not indicate the Mezzanine HBAs, and cannot be added onto because of string
size limitation.
Corrective Action:Refer to Hardware Requirements later in this document for more information.
• swverify reports inaccurate signature verification results if /tmp does not have enough free
space
When a digitally signed software in a depot is verified using swverify or a tape depot is
verified using swsign –v, the command may report inaccurate results if there is not enough
free space in /tmp.
Corrective Action: Ensure that there is more than 300 MB of free space in/tmp. A depot larger
than 10 GB may require more free space. Run the swjob command printed at the end of
swverify session and make sure there are no errors.
Compatibility and installation requirements
This section describes the compatibility information and installation requirements for this release.
For specific installation instructions, refer to the installation guide specific to your to your
FibreChannel card.
Operating system and version compatibility
The following software (or later versions) must be installed before installing the FibrChanl-01 (fcd)
driver, version B.11.23.0903 into a system:
• FibrChanl-00 (td) version B.11.23.0807 or later (for HP-UX 11i v2 Update 3)
• Product number B6191AAE, OnlineDiag bundle version B.11.23.03.xx, release in September
2004 (HWE0409)
• PHKL_33827 patch or later for HP-UX 11i v2 (needed for fcmsutil (1M) support for
options set_int_delay and get_int_delay)
• PHKL_36143 patch (needed for fcmsutil(1M) support for option sfp supported by 4Gb
Fibre Channel HBAs)
• PHKL_31500 patch or later (needed for HP-UX 11i v2)
• PHKL_31226 patch (only needed if OLAR functionality is required; applies to all cards that
have a bridge, including A9782A, A9784A, and AB465A)
• PHKL_34851 (needed for HP-UX 11i v2)
Driver bundles can be downloaded from the HP Software Depot at: http://www.software.hp.com
Patches are available from either: http://www.software.hp.com or http://itresourcecenter.hp.com
OnlineDiag is available at http://www.software.hp.com in the Enhancement releases and patch
bundles section, or on the HP-UX 11i v2 OE media (September 2004 and later). Installation
instructions are available on the Business Support Center (BSC) website at: www.hp.com/go/
hpux-diagnostics-online-docs
Requirements for Boot Support: AD193A/AD194A, 403619–B21, AB378A, AB378B, AB379A,
AB379B. A6826A. A9782A, A9784A, AB465A
To boot through the fibre channel ports on these adapters, HP recommends that you update the
EFI driver and onboard firmware to the latest version. The following table lists the recommended
EFI and firmware versions at the release of FibrChanl-01 (fcd) driver, version B.11.23.0807 or
later:
28