Software Distributor Requirements, Issues Fixed, and Workarounds HP-UX 11i v2, HP-UX 11i v3 (5900-2562, March 2013)

Table 15 Defects fixed in December 2006 release (continued)
DescriptionDefect ID
Add improved formatted manpages.JAGag13600
The swmodify man page and the on-system SD options reference at
/usr/lib/sw/sys.defaults are updated to show that adding
JAGag13978
"swmodify.loglevel=1" to /var/adm/sw/defaults file will enable logging by
swmodify invoked in a control script.
The message prefix is changed to be NOTE or ERROR for SD controller
messages showing how to access more information in the SD agent logfile.
JAGag14329
The choice of prefix is now based on whether there have been any ERROR
conditions shown in the SD controller logfile. Examples of affected messages
are:
NOTE: More information may be found in the agent logfile using the
command "swjob -a log hostname-0014 @ hostname:/".
or
NOTE: More information may be found in the agent logfile (location is
hostname:/var/adm/sw/swagent.log).
When a directory is changed to a file of a different type, the change is now
logged in swagent.log. The change is most likely intentional, but it may be
the result of accidental mis-packaging of the directory so it is reported.
JAGag16827
When a new dynamic module is installed using interactive swinstall, a popup
says the kernel will be rebuilt even though installing a new dynamic module
JAGag18718
will not by itself cause a kernel rebuild. Swinstall is fixed to not show the
popup message in that case, unless there are other reasons to show the
popup message.
swinstall and swremove man pages did not document the -x run_scripts
option. This option is now documented.
JAGag21177
Problem with gzip, swinstall, and swcopy.JAGag22312
September 2006
HP-UX 11i v2 September 2006 Update Release
SW-DIST fileset revision B.11.23.0609.052
whatstring SD-UX/B.11.31.00.132, UDL_11.23_Sep06OEUR_IC052
This release, B.11.23.0609.052, can be downloaded from the web. For more information, see
http://www.hp.com/go/SD/
Table 16 Defects fixed in September 2006 release
DescriptionDefect ID
In cases where no software is selected because match_target or
patch_match_target did not yield any matches, swinstall will now exit with a
success return code if no other selection errors occurred.
JAGae30136
When a bundle references a subproduct and the contents line includes an
"fa=" version component (i.e., a fileset architecture), the subproduct's filesets
were not included in swlist output or displayed in the SD interactive UI.
JAGaf90975
A problem in the interactive user interface could result in an unexpected abort
whenever the user navigates to the fileset view of the Disk Space Analysis
window.
JAGaf94199
The SD Provider does not return software data if the cimserver is started using
remsh and the default PATH is used. /usr/sbin is not in the default path which
JAGaf95148
results in the SD Provider not finding the swlist command. The swlist command
is used to obtain the data.
Issues fixed 17