Software Distributor Requirements, Issues Fixed, and Workarounds HP-UX 11i v2, HP-UX 11i v3 (5900-2436, September 2012)

Table 6 Defects fixed in March 2010 Web Release (continued)
Removal of base product in supersession chain results in top most supersession patch left and
intermediate patches removal. Fix will prevent removal of intermediate patches in supersession
chain.QXCR1000861380
swinstall -p exits with SUCCESS status even though one of the selection not exists on depot.
swinstall is returning with SUCCESS in selection phase. A new option enforce_selections is
QXCR1000593453
added. If enforce_selections option is set to true swinstall will exit with FAILURE, even when
any one selection fails.
SD is promoting corequisites to prerequisites in loading order. A new option
loadorder_use_coreqs is used. If loadorder_use_coreqs is set to false, SD will not promote
corequisite to prerequisite in loading order.QXCR1000951260
Enhancement is done to support relative path in source and targets.QXCR1000809519
This fix ensures that if installation of a fileset leads to an unresolved dependency and a new
fileset is selected for installation which is a descendant of the dependent fileset, SD will not
report an error.QXCR1000869644
This fix ensures that when swpackage is interrupted, the depot created is removable using
swremove, even if it is in incomplete or corrupt state.QXCR1000868916
When a depot created using swpackage -x run_as_superuser=false is removed using swremove
-x run_as_superuser=false, the following error is displayed: ERROR:
QXCR1000943545
"<hostname>:<depot_location>An update to the installed product database or depot catalog
may have errors. With this fix, the above errors should not occur.
This fix ensures that when an swcopy session fails during selection, analysis or execution for
a new target depot, the target is removable using swremove -d.QXCR1000950487
With this fix, swinstall TUI/GUI with multiple targets will not abnormally terminate on IA64
machinesQXCR1000963769
Updated SD japanese man pages for 0909 manpage conversionsQXCR1000936854
Man page changes are done to address the new option enforce_selectionsQXCR1000942660
Admin guide changes are made to support relative pathQXCR1000986937
2009
September 2009
September 2009 Release
11.11 SW-DIST fileset revision B.11.11.0909.340
11.23 SW-DIST fileset revision B.11.23.0909.340
11.31 SW-DIST fileset revision B.11.31.0909.340
The whatstring: SD-UX/B.11.31.00.194, UDL_11.31_Sep09OEUR_IC340
This release, B.11.11.0909.340, B.11.23.0909.340 and B.11.31.0909.340, can be downloaded from the web.
For more information, see http://www.hp.com/go/sd
Table 7 Defects fixed in September 2009 Web Release
DescriptionDefect ID
This fix ensures that a depot which is already empty can be removed using swremove with
the "remove_empty_depot" option set to true.
QXCR1000766167
The SD push controller (swcopy or swinstall) was using local hostname rather than fully
qualified local hostname in the RPC call.
QXCR1000913668
Issues fixed 7