Software Distributor defects fixed in HP-UX 11i v1, v2 and v3

This document provides information about the Software Distributor defects fixed in various
HP-UX 11i v1, v2 and v3 releases.
Defect Fixes
This section lists the defects fixed along with the SW-DIST fileset revision numbers. Each table
describes the defects fixed for a release.
September 2010 Web Release
11.23 SW-DIST fileset revision B.11.23.1009.352
11.31 SW-DIST fileset revision B.11.31.1009.352
The whatstring:SD-UX/B.11.31.00.204, UDL_11.31_Sep10OEUR_IC352
This release, B.11.23.1009.352 and B.11.31.1009.352, can be downloaded from the web. For more information, see
http://www.hp.com/go/sd
Table 1 Defects fixed in September 2010 Web Release
SD will not allow invisible characters in psfQXCR1000578749
The time stamp of "/usr/bin/cc" was updated after running swinstall. This was because the
Upgrade product was installed on the machine. This issue is documented as a known issue
in “Known Problems and Limitations”.QXCR1000937726
swinstall (1M) man page which says that if SW_INITIAL_INSTALL is set to any value during
a cold-install. This is not correct as Ignite-UX sets it to '0' when it is ready to build a kernel.
The decription of SW_INITIAL_INSTALL has been changed to :
This variable is normally unset. If it is set to 1, the swinstall session is being run as the back
end of an initial system software installation ("cold" install). If it is unset or set to any other
value,then it is not a cold-install session.
QXCR1000969551
This fix introduces a new option return_warning_exitcode. With this option any SD
controller commands will return 2 when there are any warnings but no errors during SD
controller operations. It is applicable only for single targetsQXCR1000972301
With this fix, when any of the GUI of swinstall, swremove and swcopy command's help
dialog box is opened, the “Missing Graphic” no longer appears. The note icon "i" is seen.QXCR1000985995
Utf8 locales will be supported in SD with this fixQXCR1000986478
This fix addresses a potential hang with 1003 version of SD, during a DRD update.QXCR1000998317
There is a problem in swask(1M) command.QXCR1001023437
With this fix the machine will be rebooted after installing a product having normal fileset
whose control script returns 12 as exit code.QXCR1000885370
The sort algorithm in tlfileset.sh in the "Upgrade" product results in poor performance of
swinstall. Since the Upgrade product is obsoloted, this issue cannot be fixed and is
documented as a known issue in “Known Problems and Limitations”.QXCR1000584047
This section lists the defects fixed along with the SW-DIST fileset revision numbers. Each table
describes the defects fixed for a release.
March 2010 Web Release
11.23 SW-DIST fileset revision B.11.23.1003.346
11.31 SW-DIST fileset revision B.11.31.1003.346
Defect Fixes 5