Software Distributor defects fixed in HP-UX 11i v1, v2 and v3

Table 8 Defects fixed in September 2007 release (continued)
DescriptionDefect ID
The description of the dynamic_module attribute in the swpackage(4)
manpage is incorrect where it says that dynamic modules must be delivered
to /stand/mod/. The manpage has been changed to specify the correct
location of /usr/conf/mod.
JAGag41035
The "remove_obsolete_filesets" option has been added to swpackage. When
the option is set to "true" and the package operation is complete, obsolete
filesets are removed from the target products that were written during
swpackage. Obsolete filesets are filesets that were not part of the product
during the most recent packaging of the product residing on the source
depot or during the current packaging of the product defined in the source
psf.
JAGag41553
June 2007 Web Release
SW-DIST fileset revision B.11.23.0706.063
whatstring SD-UX/B.11.31.00.156, UDL_11.23_Jun07OEUR_IC063
This release, B.11.23.0706.063, can be downloaded from the web. For more information, see http://www.hp.com/go/SD/
Table 9 Defects fixed in June 2007 release
DescriptionDefect ID
The swinstall analysis has been changed to not allow the newer version of
a dependency to be installed if it will not satisfy the installed dependent.
JAGaf30050
Reinstalling a patch after a failed attempt to install the same patch can result
in the second install of the patch appearing to succeed, when the second
install actually had the same failure as the first install. After the first install
the patch is marked as corrupt. After the second install the patch is marked
as configured, even though it should still be marked as corrupt. This release
of SD is fixed so failure during the second install will mark the file as
corrupt.
JAGaf41562
This release of 11.23 SW-DIST installs the gettune command. This helps
avoid setting kernel tunables incorrectly when packaged control scripts
such as preinstall, postinstall, or configure use the increase_tunable()
function on tunables that are not already shown in /stand/system.
JAGaf73460
The swcopy and swinstall commands generate a NOTE message saying
the dependency "will be checked during the analysis phase" when the
dependency is not resolved on the source during selection. The swcopy
and swinstall commands have been changed to not generate the NOTE
message if the dependency will be resolved on the target.
JAGag05772
SD has been changed to prevent a SIGSEGV when a bundle includes itself
as one of its contents and the bundle also contains a fileset that has a
requisite declared on another fileset in the bundle.
JAGag12193
When using the swreg command using the "@" to designate the target, the
message, "ERROR: More information may be found ..." will display a default
location of <target path" ": ><path>, <hostname>: <path> The fix is to handle
whether you include the "@" to designate a target or not, it will display.
JAGag21361
Problem with SD secrets file.JAGag24288
When IPD_delete_ancestors function is invoked incorrectly, it may cause
a WARNING message and an ERROR message to be logged, when only a
WARNING message is needed. It is fixed to issue only a WARNING
message.
JAGag24647
Defect Fixes 13