Software Distributor Administrator Guide (September 2010)

Table 3-2 The -l Options (continued)
ActionOption
Shows the private roots
swlist -l prroot
Shows only bundles
swlist -l bundle
Shows only products
swlist -l product
Shows products and subproducts
swlist -l
subproduct
Shows products, subproducts and
filesets
swlist -l fileset
Shows products, subproducts, filesets,
files and numbers (used in software
licensing).
swlist -l file
Shows all categories of available patches
for patches that have included category
objects in their definition.
swlist -l category
Shows all applied patches.
swlist -l patch
-s source
Specify which software source is to be listed. The default
source type is a directory or depot (usually /var/
spool/sw) on the local host. The syntax is: [host][:]-
[/directory] | [./relative_path] |
[../relative_path]
host may be a host name, domain name, or internet
address (for example, 15.1.48.23). directory is an
absolute path. To specify a relative_path when no
host is specified, the relative_path must start with
./ or ../; otherwise, the specified name is considered
as a host.
-S session_file
Run the command based on values saved from a
previous installation session, as defined in
session_file. See “Session Files” (page 52).
-t target_file
Read a list of target selections from a separate file instead
of (or in addition to) the command line.
-x option=value Sets a command option to value and overrides default
values or a values in options files. See “Changing
Command Options” (page 88).
-X option_file Read session options and behaviors from option_file.
See “Changing Command Options” (page 88).
3.1 Listing Your Software (swlist) 87