Software Distributor Administrator Guide (September 2010)

-t target_file
Read target selections from a target_file instead of
(or in addition to) targets you specify on the
command line. See “Target Files” (page 50).
-x command_option=value Sets command_option to value, overriding
default values or values in options files. See
“Changing Command Options ” (page 64).
-X option_file
Read session options and behaviors from
option_file. See “Changing Command Options
” (page 64).
software_selections
One or more software objects to be installed. See
“Software Selections” (page 47).
target_selections
The target on which to install the software
selections. See “Target Selections” (page 49).
Changing Command Options
You can change the behavior of this command by specifying additional command-line
options when you invoke the command (using the -x option) or by reading predefined
values from a file. The following table shows the defaults and options that apply to
swinstall.
64 Installing Software