Software Distributor Administrator Guide (September 2010)

the file to any selections you have already made in the Software Selection
window.
• Save Software Group lets you save your current list of marked software as
a group.
• Manage Patch Selections lets you select from a list of patches to install,
select filters for patches, and set other patch options. (See “Installing Patches”
(page 67) for more information.)
• Change Source...cancels your software selections and returns you to the
Specify Source dialog.
• Add New Codeword lets you add a new codeword to unlock protected
software. (This option is available only when SD-UX detects that the source
contains protected software.)
• Change Target... displays the Select Target Path dialog. This lets you specify
an alternate root for products that are relocatable.
• Show Description of Software (available only for a single item highlighted
in the object list) displays more information on the selected software.
3. Select Actions→Install to start the analysis (preview) step. The Analysis dialog
appears.
Step IV: Analysis (Preview)
In this step, SD-UX analyzes the software you have selected.
The Analysis window displays status information about the analysis process. When
the analysis is complete and the host status shows Ready, click OK to start the actual
installation (see “Step V: Installation” (page 61)). The Analysis dialog is then replaced
by the Install dialog.
If you started a preview session, the install stops after the analysis. Clicking Cancel
returns you to the Software Selection window.
Figure 2-3 Analysis Dialog
The following actions are available:
2.1 Installation with swinstall 59