Software Distributor Administrator Guide (September 2010)

• logdetail=false
Controls the amount of detail written to the log file. When set to true, this option
adds detailed task information, such as options specified, progress statements,
and additional summary information, to the log file.
Table A-2 shows the possible combinations of loglevel and logdetail options.
Table A-2 loglevel and logdetail Combinations
Information IncludedLog DetailLog Level
No information is written to the log file(not applicable)loglevel=0
Only key events are logged. This is the default
setting for both options.
logdetail=falseloglevel=1
Event detail as above plus task progress messages.
(Setting loglevel=1 is optional because 1 is the
default value.)
logdetail=trueloglevel=1
Event and file level messages only. (Setting
logdetail=false is optional because false is the
default value.)
logdetail=falseloglevel=2
All information is logged.logdetail=trueloglevel=2
1
1 This combination duplicates the logfile behavior as HP-UX 10.x releases. Setting both the
loglevel=2 and logdetail=true options is required.
Applies to swconfig, swcopy, swinstall, swreg, swremove and swverify.
• logfile=/var/adm/sw/<command>.log
This is the default controller log file for each command. The agent log files are
always located relative to the target depot or target root: /var/spool/sw/
swagent.log and /var/adm/sw/swagent.log, respectively.
Applies to all commands except swacl, swlist and swjob.
• loglevel=1
This option controls the log level for events logged to the command log file, the
target agent log file and the source agent log file by prepending identification
numbers to SD-UX log file messages. This information is in addition to the detail
controlled by the logdetail option. A value of:
— 0 -- provides no information to the log files
— 1 -- enables verbose logging to the log files
— 2 -- enables very verbose logging to the log files.
Applies to swconfig, swcopy, swinstall, swmodify, swpackage, swremove
and swverify.
• lookupcache_timeout_minutes=10
This option controls the time in minutes to cache and re-use the results of hostname
or IP address resolution lookups. A value of 0 disables the facility to cache and
320 Command Options