Software Distributor Administrator Guide (September 2010)

• create_target_acls=true
Normally set to true, this default determines whether swpackage creates Access
Control Lists (ACLs) in the depot.
If you set this option to false as superuser, ACLs for each new product being
packaged (and for the depot, if it is new) are not created.
When another user invokes swpackage, it always creates ACLs in the distribution
depot. This default has no impact on the ACLs that already exist in the depot. The
swpackage command never creates ACLs when software is packaged onto a
distribution tape.
Applies only to swpackage.
• create_target_path=true
Normally set to true, creates the target directory if it does not already exist.
If false, target directory is not created. This option can be used to avoid creating
new depots by mistake.
Applies to swcopy and swinstall.
• create_time_filter=0
Controls time settings for cumulative source depots. The default of zero includes
all bundles, products, subproducts, and filesets in the source depot as candidates
for selection (and autoselection of dependencies and patches), based on the software
selections and other options. When set to a time (specified as seconds from epoch),
only bundles, products, and filesets (and the subproducts in the product) with a
create_time less than or equal to the specified value are available for selection (or
autoselection).
To list the create_time of bundles, products and filesets, use:
swlist -a create_time -a create_date
Applies to swlist, swcopy, and swinstall.
• customer_id=
This number, printed on the Software Certificate, “unlocks” protected software
and restricts installation to a specific site or owner. You can enter the number with
the -x customer_id=option or by using the Interactive User Interface. See
thecodeword option for more information.
Applies to swinstall, swcopy, swlist.
• defer_configure=false
Controls the automatic running of configure scripts after swinstall software
selections are installed. The default value of false allows swinstall to
automatically run configure scripts. When set to true, swinstall does not run
A.2 Options Listed Alphabetically 313