Software Distributor Administrator Guide (September 2010)

Step II: Select Targets
The Target Selection Window displays the local, default target. A target is where you
want the installation to go (in the example below, the target is the system swbash3).
By default, the current system is listed (Figure 7-3: “Target Selection Window”,).
Figure 7-3 Target Selection Window
Specify the desired target for the installation:
1. For local default:
a. Highlight the local target system with a left mouse click. Then select
Actions→Mark for Install (or right-click to display the pop-up menu and select
Mark for Install).
b. Select Actions→Show Software for Selection...
This displays the Specify Source dialog. If this is your first time through this tutorial,
skip directly to “Step III: Select Source” (page 163). After you have gone through
this tutorial once, retry Step I using remote targets.
— or —
162 Remote Operations Overview