Software Distributor Administrator Guide (September 2010)

swpackage -s psf @ /var/adm/sw/examples/depot
swreg -l depot @ /var/adm/sw/examples/depot
7. To verify that the software is in the depot and is available for distribution to targets,
enter:
swlist -s /var/adm/sw/examples/depot
You should see SD-DATABASE in the resulting list.
7.4.2 How to Perform a Single-Target Installation
Overview
The tutorial consists of these steps:
Table 7-2 Installation Steps
Overview of Installation Steps
Start the Job Browser.I. Start-up
Specify the targets where you want the software installed. You can use the
default local target or specify another target.
II. Select Targets
Provide the location of the software depot from which the software will be
installed with the Specify Source dialog.
III. Select Source
Use the Software Selection Window to select the software to install.IV. Select Software
Use the Install Preferences dialog box to set preview or scheduling options.V. Specify Install
Preferences
Perform the actual software installation or preview.VI. Analysis and
Installation
Monitor job progress and results using the Job Browser GUI.VII. Monitor Results
Delete the completed jobs using the Job Browser.VIII. Remove Jobs
Step I: Start-up
To initiate an install session:
1. Start the Job Browser by typing:
sd
2. From the Job Browser window, choose
ActionsCreate JobInstall Software...
The message “Invoking a swinstall process” displays at the bottom of
the window, then the Target Selection Window appears.
7.4 Remote Operations Tutorial 161