Software Distributor Administrator Guide (September 2010)

Syntax
swjob [XToolkit_Options][-i][-R][-u][-v][-a attribute] [-C session_file][-f jobid_file]
[-S session_file][-t target_file][-x option=value]
[-X option_file][jobid][@ target_selections]
Options and Operands
XToolkit_Options
X window options for use with swjob -i. See “XToolkit
Options and Changing Display Fonts ” (page 46).
-i
Starts the SD interactive job browser. See “Using the Job
Browser ” (page 138).
-u Causes swjob to remove the specified jobs.
-v
List all available job attributes, one per line.
-a attribute
Display a specific attribute for the job. See “swjob Tasks
and Examples” (page 149) for more information.
-C session_file
Run the command and save the current option and operand
values to a session_file for re-use in another session. See
“Session Files” (page 52).
-f jobid_file
Read a list of job IDs from a separate file instead of (or in
addition to) jobs you specify on the command line. (Use
these files just like software files. See “Software Files”
(page 49).)
-R
Applies to target lists as a shorthand for @ *::*.
-S session_file
Run the command based on values saved from a previous
installation session, as defined in session_file. See
“Session Files” (page 52).
-t target_file
Read a list of target selections from a separate file instead
of (or in addition to) those you specify on the command
line. See “Target Files” (page 50).
-x option=value Sets a command option to value and overrides default
values or a values in options files. See “Using Command
Options” (page 50).
-X option_file Read session options and behaviors from option_file.
See “Using Command Options” (page 50).
jobid
One or more identification numbers for an SD-UX operation.
You can read jobid numbers from the Job Browser when
you set up or monitor your jobs interactively.
target_selections
The target of the command. See “Target Selections”
(page 49).
148 Using Jobs and the Job Browser