Software Distributor Administration Guide (March 2009)

Window. Networking may cause delays; if the SD-UX daemon is not running on
the target, the delay lasts until the daemon times out.
From the Target Selection Window, any targets added using Add Targets... are
automatically marked Yes.
6. If there are any other desired targets in the Target Selection List that are not marked
and you want to install to them, highlight the target by clicking on it.
Choose Actions→Mark for Install. The Marked? column is set to Yes for that
target.
— or —
Hold down the right mouse button and choose Mark for Install from the resulting
menu.
7. To unmark a target in the Target Selection Window (i.e., object list):
a. Highlight the target
b. Choose Actions→Unmark for Install. The Marked? column is cleared for that
target.
— or —
Hold down the right mouse button and choose Unmark for install.
At this point, all desired targets should be listed and have Yes in the Marked? column.
If you have not marked any targets, you cannot proceed to the Selecting Software phase.
7.2.4 Selecting Individual Targets
You can add or delete individual targets.
To add a new target:
1. Select Actions→Add Targets.... The Add Targets dialog appears.
2. Type in the name of the desired target and click on Add. The Select Target Path
dialog appears.
3. Click OK to accept the default (/) or click on the Root Path...button to display the
Shared Root Paths dialog, which contains more selection options.
4. Select the desired root and click OK to return to the Select Target Path dialog.
5. Click OK to return to the Add Targets dialog
6. Click OK. You have now marked an additional target.
To delete targets, select one or more targets from the Target Selection Window, then
select Actions→Unmark for Install.
7.2.5 Saving a Target Group
You may want to re-use your list of targets for a later session. To do so,
156 Remote Operations Overview