Software Distributor Administration Guide (March 2009)

-Q date
Schedules a job for the given date when remote
operations are enabled. See “Scheduling Jobs from the
Command Line” (page 148) and Chapter 7: “Remote
Operations Overview” (page 151)
-S session_file
Run the command based on values saved from a
previous removal session, as defined in session_file.
See “Session Files” (page 51).
-t target_file
Read a list of target selections from a separate file instead
of (or in addition to) the command line. See “Target
Files” (page 49).
-x option=value Sets a command option to value and overrides default
values or a values in options files. See “Changing
Command Options” (page 107).
-X option_file Read session options and behaviors from option_file.
See “Changing Command Options” (page 107).
software_selections
The software objects to be removed. See “Software
Selections” (page 47).
target_selections
The target of the command. See “Target Selections”
(page 49).
Changing Command Options
You can change the behavior of this command by specifying additional command-line
options when you invoke the command (using the -xoption) or by reading predefined
values from a file. The following table shows the defaults and options that apply to
swremove.
3.3 Removing Installed Software (swremove) 107