Software Distributor Administration Guide HP-UX 11i v1, 11i v2, and 11i v3 (5900-2561, March 2013)

WARNING: A version of fileset "SD-DATABASE.SD-DATABASE2,r=9.00.1C"
is already installed in another location (see previous
lines). Installing this version will create multiple
installed versions. This new multiple version will be
installed because the "allow_multiple_versions" option is
set to "true".
B.1.3 Notes
Notes are used to notify you of an event that is not erroneous, unexpected or undesirable, but that
you should be aware of:
NOTE: The fileset "SD-DATABASE.SD-DATABASE1,r=9.00.1C" is
already installed. If you wish to reinstall this
fileset, change the "reinstall" option to "true".
B.2 Common Problems
This section presents a selection of problems you might encounter and how to resolve them:
Table 56 Common Problems
Problem
Cannot contact target host’s daemon or agent
GUI won’t start or missing support files
Access to an object is denied
Slow network performance
Connection timeouts and other WAN problems
Disk space analysis is incorrect
The packager fails
Daemon logfile is too long
Cannot read a tape depot
Installation fails
swinstall or swremove fails with a lock error
Use of square brackets ([ and ]) around IPv6 address causes an error
B.2.1 Cannot Contact Target Host’s Daemon or Agent
If you see the following error message:
ERROR: Could not contact host <hostname>. Make sure the
hostname is correct.
it means that the hostname you specified could not be found in the hosts database. Make sure you
have typed the hostname correctly (you can use the nslookup command to verify hostnames). If the
target hostname is not in the hosts database, but you know its network address, you can use it (in
standard “dot” notation) in place of the hostname.
If you see this error message:
ERROR:Remote Procedure Call to a daemon has failed.
Could not start a management session for <target>.
Make sure the host is accessible from the network,
and that its daemon, swagentd, is running. If the
daemon is running see the daemon logfile
on this target for more information.
262 Troubleshooting