Software Distributor Administration Guide HP-UX 11i v1, 11i v2, and 11i v3 (5900-2561, March 2013)

When source_depot_audit is set to its default value of true, a swaudit.log file is
created on the source depot (for writable directory depots) or in /var/tmp (for tar images,
CD-ROMs, or other nonwritable depots).
To view, print, or save the audit information, invoke the swlist interactive user interface by
typing:
swlist -i -d
You can view audit information based on language preference, as long as the system has the
corresponding SD-UX message catalog files on it. For example, you can view the source audit
information in Japanese during one invocation of swlist, then view the same information
in English at the next invocation.
Applies to swagent.
• source_directory
See distribution_source_directory.
• source_file=psf
This keyword defines the default product_specification_file to read as input to the
packaging or swmodify session. It may be a relative or absolute path.
Applies to swpackage and swmodify.
• source_tape=/dev/rmt/0m
Defines the default tape location, usually the character-special file of a local tape device. You
can also use the host:path syntax, but the host must match the local host. The -s option
overrides this value.
Applies to swcopy and swinstall.
• source_type=directory
The default source type (choices are cdrom, file, directory, or tape) that points to one
of the next three options. The source type derived from the -s source file option overrides
this default.
The cdrom and tape values apply to swcopy and swinstall. The file value applies
only to swpackage.
• srp_parallel=6
This option is only supported in a HP-UX Containers (SRP) enabled system. It enables the
parallel installation mode on containers. SD limits the number of concurrent install operations
on containers to the number specified. When an install operation is complete on one container,
another container gets selected and the installation begins. This process continues until
installation is complete on all containers.
Server and disk performance determines the optimal setting; the default value is 6.
A value of:
0 or 1 disables parallel installation mode. Installation runs in serial mode on one
container at a time.
* Installation runs concurrently on all containers.
Applies to swinstall, swremove, and swconfig.
• system_file_path=/stand/system
The path to the kernel’s template file. The path is passed to the system_prep_command via
the SW_SYSTEM_FILE_PATH environment variable.
Applies only to swagent.
258 Command Options