Software Distributor Administration Guide HP-UX 11i v1, 11i v2, and 11i v3 (5900-2561, March 2013)

software_selections The software objects to be installed. See “Software Selections”
(page 35).
If you do not include this specification, swpackage packages all
the products listed in the PSF.
@ target_ selections The target of the command. See “Target Selections” (page 37).
If you are creating a distribution depot (directory), this operand
defines the location of the directory. Without this operand,
/var/spool/sw is used as the default depot directory.
If you are creating a distribution tape, this operand names the
device file on which to write the tar archive. swpackage must
be able to determine if the media is a DDS tape or a disk file.
Without this operand, swpackage uses the device file, /dev/
swtape.
Changing Command Options
You can change the behavior of this command by specifying additional command-line options
when you invoke the command (using the -xoption) or by reading predefined values from a file.
The following table shows the options and default values that apply to swpackage.
Table 48 swpackage Command Options and Default Values
• loglevel=1
• lookupcache_timeout_minutes=10
• media_capacity=1330
• media_type=directory
• package_in_place=false
• reinstall_files=true
• reinstall_files_use_cksum=true
• remove_obsolete_filesets=false
• run_as_superuser=true
• software=
• source_directory=
• source_files=psf
• source_type=directory
• target_directory=
• target_tape=
• targets=
• uncompress_cmd=
• verbose=
• write_remote_files=false
• admin_directory=/var/spool/sw
• allow_large_files=false
• allow_large_serial_depot=false
• allow_partial_bundles=true
• compress_command=/usr/contrib/bin/gzip
• compress_files=false
• compress_index=false
• compression_type=gzip
• create_target_acls=true
• distribution_source_directory=/var/spool/sw
• distribution_target_directory=/var/spool/sw
• distribution_target_serial=/dev/rmt/0m
• enforce_dsa=true
• follow_symlinks=false
• include_file_revisions=false
• layout_version=1.0
• log_msgid=0
• logdetail=false
• logfile=/var/adm/sw/swpackage.log
For More Information
See Appendix A (page 235) for complete descriptions of each default.
10.5 Packaging the Software (swpackage) 199