Software Distributor Administration Guide HP-UX 11i v1, 11i v2, and 11i v3 (5900-2561, March 2013)

Table 3 SD Commands (continued)
More InformationDescription/FeaturesCommand & Manpage
• “Copying Software Depots” (page 86)• Copies software from one depot to
another
• Optional GUI
swcopy(1M)
• “Removing Installed Software (swremove)”
(page 78)
• “Removing Software from Depots” (page 102)
• Removes installed software or software
in a depot
• Optional GUI
swremove(1M)
• Chapter 10: “Creating Software Packages
” (page 171)
• Creates packages of software which
can then be used as a source for other
SD-UX commands
swpackage(1M)
• “Configuring Your Installation (swconfig)”
(page 53)
• Chapter 11: “Using Control Scripts ”
(page 207)
• Runs configuration scripts on installed
software
• Configures, reconfigures, or
unconfigures
swconfig(1M)
• Chapter 11: “Using Control Scripts ”
(page 207)
• “Requesting User Responses (swask)”
(page 227)
• Runs interactive request scripts that
gather information for later use by
swinstall or swconfig
swask(1M)
• Chapter 9: “SD-UX Security ” (page 145)• Specifies, lists, and changes Access
Control Lists (ACLs) for SD security.
swacl(1M)
• “Verifying Your Installation (swverify)”
(page 58)
• “Verifying a Depot (swverify -d) ” (page 102)
• Verifies the integrity of installed software
or depot software by comparing IPD
information with the files actually
installed
• Runs verify and fix scripts
swverify(1M)
• “Modifying the IPD (swmodify)” (page 74)• Modifies the Installed Products Database
(IPD) and various catalog files that
contain information about the software
on the system
swmodify(1M)
• “Registering and Unregistering Depots
(swreg) ” (page 95)
• Registers newly created depots to make
them visible to other systems
swreg(1M)
• Chapter 7: “Remote Operations Overview”
(page 119)
• Chapter 6: “Using Jobs and the Job Browser”
(page 105)
• Starts the Job Browser GUI to create,
monitor, schedule, and delete jobs
• Requires that remote operations are
enabled
sd(5)
• “Monitoring Jobs from the Command Line”
(page 114)
• Chapter 7: “Remote Operations Overview”
(page 119)
• Chapter 6: “Using Jobs and the Job Browser”
(page 105)
• Monitors jobs from the command line
• Requires that remote operations are
enabled
swjob(1M)
• Appendix C (page 271)• Re-installs SD-UX from media
install-sd(1M)
• See manpage• Daemon for SD-UX commands
• Must be scheduled before a system is
available as a destination for SD-UX
commands
swagentd(1M)
18 Introduction to Software Distributor