Software Distributor Administration Guide for HP-UX 11i

Installing Software
Verifying Your Installation (swverify)
Chapter 2 93
-X
option_file
Read session options and behaviors from
option_file .
See “Changing Command Options” on page 93.
software_selections
The software objects to be verified. See “Software
Selections” on page 56.
target_selections
The target of the command. See “Target Selections” on
page 58.
Changing
Command Options
You can change the behavior of this command by specifying additional
command-line options when you invoke the command (using the -x
option) or by reading predefined values from a file. The following table
shows the defaults and options that apply to swverify.
For More
Information
See Appendix A, “Command Options,” on page 421 for more information
about setting options and a complete listing and description of each
option.
Table 2-6 swverify Command Options and Default Values
• admin_directory=/var/spool/sw
• agent_auto_exit=true
• agent_timeout_minutes=10000
• allow_incompatible=false
• allow_multiple_versions=false
• autoremove_job=false
• autoselect_dependencies=true
• check_contents=true
• check_contents_uncompressed=
false
• check_contents_use_cksum=tru
e
• check_permissions=true
• check_requisites=true
• check_scripts=true
• check_volatile=false
• controller_source=
• distribution_target_directory= /
var/spool/sw
• enforce_dependencies=true
• installed_software_catalog=prod
ucts
• job_title=
• log_msgid=0
• logdetail=false
• logfile=/var/adm/sw/swverify.log
•loglevel=1
• mount_all_filesystems=true
• reuse_short_job_numbers=true
• rpc_binding_info=
• ncacn_ip_tcp:[2121]
• ncadg_ip_udp:[2121]
•rpc_timeout=5
• run_as_superuser=true
• select_local=true
•software=
•verbose=1