Software Distributor Administration Guide for HP-UX 11i

Command Options
Options Listed Alphabetically
Appendix A 455
Nonprivileged mode is intended only for managing applications that
are specially designed and packaged. This mode cannot be used to
manage the HP-UX operating system or patches to it. This option is
not compatible with remote operations. Setting this option to true
forces the autoremove_job option to true. For a full explanation of
nonprivileged SD-UX, see Chapter 12, “Nonprivileged SD,” on
page 413.
See also the admin_directory option.
Applies to all commands except swagent, swagentd, and install-sd.
• select_local=true
Normally set to true, selects the default depot or installation
directory of the local host as the target of the command.
Applies to swacl, swconfig, swcopy, swinstall, swlist, swreg,
swremove, swverify.
• show_superseded_patches=false
If false, swlist will not display superseded patches. To see them, you
must set this option to true. Even if you explicitly swlist the
superseded patch, it will not display unless this option is true.
Applies only to swlist.
• software=
Defines the default
software_selections .
There is no supplied default. If there is more than one
software_selection , they must be surrounded by brackets { } or
quotes. Software is usually specified in a software_selections input
file, as options on the command line or in the GUI or TUI.
Applies to all commands except swreg.
• software_view=products
Indicates which software view is to be used in the GUI. It can be set
to products, all_bundles, or a bundle category tag (shows only
bundles of that category). The default view is all_bundles plus
products that are not part of a bundle.
Applies to swcopy, swinstall, swlist and swremove.