Software Distributor Administration Guide for HP-UX 11i

Command Options
Options Listed Alphabetically
Appendix A444
• logfile=/var/adm/sw/<command>.log
This is the default controller log file for each command. The agent log
files are always located relative to the target depot or target root:
/var/spool/sw/swagent.log and /var/adm/sw/swagent.log,
respectively.
Applies to all commands except swacl, swlist and swjob.
• loglevel=1
This option controls the log level for events logged to the command
log file, the target agent log file and the source agent log file by
prepending identification numbers to SD-UX log file messages. This
information is in addition to the detail controlled by the logdetail
option. A value of:
— 0 -- provides no information to the log files
— 1 -- enables verbose logging to the log files
— 2 -- enables very verbose logging to the log files.
Applies to swconfig, swcopy, swinstall, swmodify, swpackage,
swremove and swverify.
• match_target=false
If set to true, forces selection of filesets from the source that match
filesets already installed on the target system.
Filesets on the source which specify an installed fileset as an
“ancestor” will be selected.
This option overrides any other software selections.
Selections cannot be ambiguous.
Applies only to swinstall.
• max_agents=-1
The maximum number of agents that are permitted to run
simultaneously. The value of -1 means there is no limit.
Applies only to swagentd.