Release Notes For SoftBench 6.80

Release Notes For SoftBench 6.80
Compatibility Information and Installation Requirements
Chapter 1 15
Installation Problems
• Installing SoftBench 6.X removed SoftBench 5.X from your system
To restore SoftBench 5.X:
1. Remove SoftBench 6.X.
2. Reinstall Softbench 5.X.
3. Install any SoftBench 5.X patches.
4. If you removed your Softbench 5.X licenses, you need to reinstall them.
5. Perform the command:
mv /opt/softbench/config.5x /opt/softbench/config
This command restores any SoftBench customizations you had made to your system. It
also prepares your system for a move to a newer version of SoftBench in the future.
• Possible error when updating from SoftBench 5.25 to SoftBench 6.80
If you have the SoftBench 5.25 cumulative patch, PHSS_15632, installed on your system
you may get WARNING and ERROR messages when you update your system to Softbench
6.80. The WARNING and ERROR messages occur when this patch is automatically removed
during the SoftBench 6.80 update installation. The WARNING and ERROR messages can
safely be ignored. The output file, /var/adm/sw/swagent.log appears as follows:
* Software selections:
SB-SoftBenchCore.SB-GNUBIN-MAN
* File selections:
/opt/softbench/config/buildt/include/f90.rules
* Beginning Modification Phase.
WARNING: Cannot delete the definition for
“/opt/softbench/config/buildt/include/f90.rules” from the
fileset “SB-SoftBenchCore.SB-GNUBIN-MAN”.The file does not
exist in this fileset.
ERROR:The selected software was not modified. All of the specified
file modifications are invalid. See the ERROR and/or WARNING
messages above.